CCNA CCSP Training - Setting the system clock ASA
As a CCNA / CCSP candidates who understand how to set up the system drive on your ASA.
Set the correct time on the security device configurations is probably one of the most important decisions to make. The safety device is the time to use the system clock for stamping of syslog messages before sending the system clock is controlled even when the VPN tunnel using PKI (Public Key Infrastructure), asIf the VPN peer presented the certificate is not valid for the safety of the certification system, the validity is checked against Clock, if the system is wrong, then the certificate.
Manually adjust the clock.
Set the clock of a safety device is similar to setting the clock on a Cisco IOS router. Use the "Clock" command to set the system clock. If the watch is the ASA to upgrade the system BIOS, thePowered by a battery on the motherboard is, then, that the ASA and then again, the system needs time to be reconfigured. If the system clock just browse through the ASDM Device Configuration Manager> Settings> System time and enter a time zone, date and time.
The SAA to see the time zone after time, when time stands still in Coordinated Universal Time (UTC) and shows the time in which ever time zone you have configured. The ASA will continue toTaking into account daylight saving time (DST), but if you want you could manually replace the summer is the specific date and time or date and time applicants.
ASA (config) # clock summer-time GMT return Thursday, September 30 6:00 last Sun Apr 06:00
Auto Clock Set
ASA The device also enables support for Network Time Protocol (NTP) to synchronize the system clock to an NTP server, this is the preferred method for manyAdministrator, as there is no need to update the system clock is synchronized with the NTP to keep clocks very important for the use of PKI (certificates) to authenticate users or devices.
If you use the installation system clock via the NTP ASDM, go to Device Manager Configuration> Settings> System> Time NTP> Add and enter:
NTP server IP address.
Preferred Server box if they are given two or more servers and less accurate, you may prefer to select the ASAa;
Insert the interface that the NTP server, based
number key and the key value to specify the number of key authentication and key.
Trusted key is to specify the authentication key for all NTP servers configured.
Authenticate, this is to enable authentication.
To check the status of NTP, run the following command
ASA (config) # show ntp status
Danos tu comentario
Post a Comment