Cisco CCNA, CCNP, and CCENT Practice Questions - RIP, VLANs, HSRP, and More!

We test your knowledge of RIP, Easy VPN Server, VLANs, Cisco and other topics important certification exam! The answers can be found at the end of the article to be found.

CCNA:

What would each show command RIP-value double in the next edition of the command?

R1 # show IP protocols
Routing Protocol is "rip"
Sending updates every 30 seconds
Keep Invalid after 180 seconds, 180, flushed after 240

CCENT Certification:

SixThe configuration of a Cisco switch and attempt to create a place in a port VLAN that is not yet. What will happen, and what message one might expect to see?

CCNA Security Certification / CCNP ISCW exam:

Working in SDM to configure an Easy VPN Server. There are three options for authenticating your Easy VPN Client. What?

CCNP Certification / BSCI exam:

What do the following IPv4 fields have in common, that tell themIPv6?

Header Length
Identification
Flags
Fragment Offset
Header Checksum

CCNP Certification / BCMSN exam:

What can a single word HSRP router to take over the active router if the current route of Active's online?

CCNP / ONT Exam:

What header RTP header compression?

Here are the answers!

CCNA: Answer: To change the order of fundamental values RIP timers. To double each value, we would have the followingCommand:

R1 (config-router) # timers basic 60360360480

CCENT: Answer: The switch will dynamically create the VLAN and send you a message indicating that only. Here is the message I received when placing a port in VLAN 500, a VLAN that did not have this option:

SW1 (config) # int fast 0 / 1
SW1 (config-if) # switchport mode access
SW1 (config-if) # switchport access VLAN 500
% Access VLAN does not exist. Creating VLAN-500

CCNA Security / ISCW exam answer:The choices are pre-shared keys, digital certificates, and both.

CCNP BSCI Answer: None of them made the cut to IPv6 - are fields of IPv4.

CCNP BCMSN response prevention. In the following example, R2 was not the active router, even if its priority is higher than the active router. After reconfiguring R2 prevent priority statement with the option, the Active router R2.

Note that can anticipate now appears in the output of SHOW idleR2.

R2 (config-if) # standby 5 priority 150 preempt

1d11h:% STANDBY-6-State Change: Ethernet0 Group 5 state Standby -> Active

R2 # show standby
Ethernet0 - Group 5
Local state is Active, priority 150, may preempt
Hello time 4 sec, wait time 12 sec
Next hello sent in 1.844
Virtual configured IP address 172.12.23.10
Active router is local
Standby router 172.12.23.3 expires in 10.204
Virtual MAC address is 0000.0c07.ac05
2 changes state, the changeState change 00:00:13

CCNP ONT Answer: RTP HC will compress the headers of RTP, sure - but it will also compress IP and UDP headers.

RTP compression can cause a lot of overhead reduction. Consider those three headers and their size:

IP header: 20 bytes
UDP header: 8 bytes
RTP header: 12 bytes

HC show that RTP header total size, across 2-4 bytes, depending on their documentation decreases lead.

More freeCisco certification exam questions practice on my site like this!

Visit : MP3 Player remotepcaccess hpc4680